Door window rear guide rail
|
Door window rear guide rail
|
1.
|
Remove the door trim. See
.
|
2.
|
Fold down the water drainage.
|
3.
|
Raise the window completely.
|
4.
|
Remove the rubber plug at the bottom of the side of the door.
|
5.
|
Note its position and then remove the adjuster screw for the rear guide rail.
|
6.
|
Remove the screw securing the top end of the guide rail.
|
7.
|
Carefully bend the door window outwards and unhook the top end of the guide rail from the door panel.
|
8.
|
Lift up the guide rail and pull it from the plastic bushings on the back edge of the window.
|
The window must be in a raised position before starting.
1.
|
Incline the window slightly and guide the guide rail onto the plastic bushings on the window. Hook the rail into the hole in the door panel.
|
2.
|
Tighten the screws securing the top of the guide rail.
|
3.
|
Tighten the adjuster screw at the bottom of the guide rail as marked.
|
4.
|
Adjust the door window. See
.
|
5.
|
Put back the rubber plug.
|
6.
|
Put back the water drainage.
|
7.
|
Put back the door trim. See
.
|