Seat chassis, electrically adjustable seat
Seat chassis, electrically adjustable seat |
1. |
Raise the seat as far as it will go.
|
2. |
Remove the seat,
.
|
3. |
Remove the wiring from the switches
.
|
4. |
Remove the wiring from the backrest rake angle adjustment motor
.
|
5. |
Remove the backrest heating pad connector.
|
6. |
Remove the relay holder by drilling out the pop rivet heads. Unplug the 8-pin connector in the seat frame.
|
7. |
Remove the seat chassis retaining bolts.
|
To fit |
Fit in reverse order.
Important | ||
Make sure that the wiring is fitted in the same position as before, so that it will not be nipped when the seat is adjusted. |
||
Tightening torque:
Seat chassis retaining bolts: 24 Nm (18 lbf ft)