SAAB WIS ONLINE

Gear change mechanism

Gear change mechanism

Dismantling and assembling


For cars equipped with the Sensonic system, this text supplements the text in the section headed "Gear change mechanism, dismantling and assembling" in "Manual gearbox" .


1. Remove the gear selector position sensor, see .

2. Follow the instructions under "Dismantling the gearbox" in the section "Manual gearbox" up to and including the point where the gear-changing mechanism is lifted out.

3. Place the gear change mechanism in a screw vice with protective jaw faces.

4. Tap out the clamping pin for the gear change lever's shaft.

5. Withdraw the spring pin for the gear selector position sensor's shaft.

6. Tap out the shaft and remove the selector lever.

7. Place the gear-changing lever with springs and sleeves in the bearing bracket. Press in the shaft with the elongated groove facing as shown. Drive in the spring pin.


8. Drive in the spring pin for the gear selector position sensor's shaft with the opening facing towards the spring pin for the gear-changing lever's shaft, as shown. It must not bottom but allow the gear-changing lever to move with ease.

9. Follow the instructions under "Assembling the gearbox" in "Manual gearbox" from the point where the gear-changing mechanism is lifted in place.

10. Fit the gear selector position sensor in place, see .