SAAB WIS ONLINE

Control wire

Control wire


To remove


1. Remove the control panel. See .

2. Remove the two clips holding the wire to the climate control unit and then remove the wire. V


To fit



1. Refit the control wire at the rear of the control panel. The wire should be positioned above the control shaft.

2. Press on the clip securing the wire.

3. Refit the control panel.

4. Refit the wire on the lever of the air-blending flap.


5. Turn the heating knob to full cooling.

6. Hold the knob securely and at the same time push the control lever of the air-blending flap forward as far as possible.

7. Press into place the clip holding the wire sheathing to the climate control unit.

8. Check that the heater knob can be turned to both end positions without springing back.

9. Refit the panel on the centre console.