SAAB WIS ONLINE

Contact roller

Contact roller

Warning

Read the Safety and handling instructions before starting work.


To remove


1. Ignition in OFF position. Remove the negative cable on the battery.

2. Remove the plug over the screws and remove the screws securing the airbag, 2 pcs.

3. Lift out the airbag and unplug the connector.

4. Unplug the horn connector.

5. Position the wheels in the straight forward position.

6. Remove the nut and lift off the steering wheel.

7. Remove the upper and lower steering column covers, 3 screws.

8. Remove the screws securing the contact roller, 2 pcs.

9. Unplug the connectors and lift off the contact roller.


To fit


1. Open the transport lock on the contact roller.

2. Fit the contact roller in place and plug in the connector.

3. Tighten the screws securing the contact roller, 2 pcs.

4. Fit the upper and lower steering column cover, 3 screws.

5. Set the contact roller centre position as follows:

5.a. Check that the wheels are pointed straight forward.

5.b. Turn the contact roller clockwise to its end position.

5.c. Turn back the contact roller 2 turns.

6. Place the steering wheel in position and tighten the steering wheel nut.

Tightening torque: 39 Nm (28.8 lbf ft)

7. Plug in the horn connector.

8. Connect the airbag connector to the airbag.

9. Tighten the screws securing the airbag and then fit the plugs over the screws.

10. Connect the negative cable on the battery and turn on the ignition.

11. Connect the diagnostic tool to the data link connector under the dashboard and clear any diagnostic trouble codes.

Turn the ignition off and on again. Wait at least 10 seconds with the ignition on. Check whether a diagnostic trouble code is shown.

If a diagnostic trouble code is shown:

Perform the relevant fault diagnosis according to the instructions in the: Fault diagnosis, general .

If no diagnostic trouble code is shown:

Refit the items you have removed.