SAAB WIS ONLINE

Soft top assembly

Soft top assembly

To remove


1. Lower the soft top and position the soft top cover straight up.


2. Remove the side trim. See .

3. Unplug the electrical connectors.


4. Remove the nuts securing the soft top.

Important

Place something between the soft top and the sides of the soft top storage to protect it.


5. With the aid of an assistant, lift up the soft top and unplug the electrical wiring. Note the number of shims on the right and left-hand sides. The same number of shims must be replaced when fitting a new soft top.


To fit


1. Put the shims in place on the soft top.


Important

Place something over the sides of the soft top storage as protection.


2. Insert the electric wiring.

3. Put the soft top into position. Guide it in place with two 10 mm drills, one on each side.

4. Tighten the nuts.

Tightening torque 28 Nm (20.7 lbf ft)

5. Plug in the connectors and fasten the wiring.

6. Check the fit and profile of the soft top. See

7. Refit the side trim. See page .

8. Connect the diagnostic tool, clear any diagnostic trouble codes and then program the control module. See .