Applies only to the SE, GB and DE markets: Before replacing the control module, carry out regular fault tracing as per WIS and go through Checklist prior to CIM replacement.
| To remove |
| 1. | Carry out "Procedure before removing the control module". | |
| 2. | Remove the gaiter from the control module and press it against the instrument panel.
 | |
| 3. | Remove the control module from the steering shaft. Press in the steering column while pulling the control module outwards.
| ||||||||||
| 4. | Unplug the connector and remove the clip. | |
| To fit |
| Important | ||
Take care when plugging in the connector so as not to damage or press out the pins/sleeves in the connector. For further information regarding connectors, refer to Connectors, handling and inspection. | ||
| 1. | Plug in the control module connector and fit the clip. | |
| 2. | Fit the control module to the steering shaft. | |
| 3. | Fit the gaiter to the control module. | |
| 4. | Make sure that the wheels are pointing straight ahead. Turn the contact roller so that the pointer is in the middle of the indicator opening. | |
| 5. | Fit the Steering wheel. | |
| 6. | Carry out "Procedure after changing the control module". | |