Pre-delivery service |
1. | Unlock the car.
|
2. | Remove the plastic paint protector. |
3. | CV: Remove the protection from the soft top.
|
4. | Remove the transport supports from the suspension. From and including VIN 81122974 (4D/5D) see Transport support VIN 81122974 (4D/5D) - |
5. | Remove the transport protection from the brake discs and the label from the windscreen. |
6. | Perform Battery check during pre-delivery service.
|
7. | Fit the battery cover.
|
8. | Adjust tyre pressure (including the spare tyre, if included). |
9. | Cars with steel rims: Fit the hub caps. |
10. | Check level of fluids and top up as required. |
- | Washer fluid |
- | Engine oil |
- | Coolant |
- | Brake fluid |
- | Power steering fluid |
11. | Remove the protection from the following places in the cabin: |
- | the seats |
- | the rear seat |
- | the gear lever/selector |
- | the steering wheel |
- | the floor |
- | the door trim on the driver's side |
- | the front sills |
- | the lower dashboard |
- | Cars with navigation system: the navigation unit display. |
12. | Put in place the extra carpet (not US/CA). |
13. | Remove the VIN label from the side window in the rear door.
|
14. | Remove the items packed in the glove box. |
- | Fit the cover over the lock cylinder on the front left door. |
- | Theft alarm label, to fit (not US/CA). |
- | EU: Place the Certificate of Conformity in the owner's manual folder. |
- | CV: Fit the radio antenna rod. |
- | Cars with navigation system: Load the map disc in the navigation unit's DVD player. CV: The navigation disc is factory-inserted; check! |
- | Fit wheel bolt caps. |
15. | Set date and time.
|
16. | Check the function of the wash/wipe system. |
17. | Clear fault codes in all systems. |
18. | Perform Configuration of dipped beam/front fog lights. |
19. | Fit the foam to the number plate as instructed (does not apply to JP and KR). Mount number plates. |
20. | Cars with pinch protection: Remove fuse F5 in the instrument panel. Fit fuse F5. Carry out Programming pinch protection. |
21. | Test-drive the car. |
22. | Make sure no fault codes have been detected in any of the systems. |
23. | Remove the towing eye, close the cover, remove the spare wheel and place the towing eye in the toolbox. Fit the spare wheel, if present. |
24. | Clean the car. |