DTC C0110 |
Diagnostic Instructions |
• |
Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• |
Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• |
Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptors |
Diagnostic Fault Information |
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
B+ |
C0110 06 |
C0110 06 |
- |
- |
Ground |
- |
C0110 06 |
- |
- |
Component | Condition | DTCs | |||||||||
Pump Motor |
|
C0110 61 |
Circuit/System Description |
Conditions for Running the DTC |
Conditions for Setting the DTC |
• |
A short to ground or an open/high resistance is detected on the pump motor B+ circuit for 0.01 s. |
• |
An open/high resistance is detected on the pump motor ground circuit for 0.05 s. |
Action Taken When the DTC Sets |
• |
The EBCM disables the ABS, traction control, stability control and hill start assist for the duration of the ignition cycle. |
• |
The ABS indicator turns ON. |
• |
The traction control/stability control active indicator turns ON. |
• |
The brake warning indicator turns ON. |
Conditions for Clearing the DTC |
• |
A current DTC clears when the diagnostic runs and passes. |
• |
The EBCM will turn OFF the indicators in the next ignition cycle. |
Reference Information |
• |
Circuit Testing
|
• |
Connector Repairs
|
• |
Testing for Intermittent Conditions and Poor Connections
|
• |
Wiring Repairs
|
Circuit/System Testing |
1. |
Ignition OFF, disconnect the harness connector at the K17 Electronic Brake Control Module. |
2. |
Test for less than 10 Ω between the ground circuits listed below and ground. |
• |
Terminal 13 |
• |
Terminal 38 |
3. |
If greater than the specified range, test the ground circuit for an open/high resistance. |
4. |
Verify that a test lamp illuminates between the B+ circuit terminal 1 and ground. |
5. |
If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance. |
6. |
If all circuits test normal, replace the brake pressure modulator valve assembly and verify the DTC does not reset. |
7. |
If the DTC resets, replace the K17 Electronic Brake Control Module. |
Repair Instructions |
• |
Electronic Brake Control Module Replacement
|
• |
Control Module References for EBCM replacement, setup and programming |