SAAB WIS ONLINE

DTC P0038 HO2S HEATER CONTROL CIRCUIT HIGH (BANK 1 SENSOR 2)

DTC P0038 HO2S HEATER CONTROL CIRCUIT HIGH (BANK 1 SENSOR 2)

DTC DETECTING CONDITION:


• Immediately at fault recognition

• GENERAL DESCRIPTION


Important

After repair or replacement of faulty parts, conduct Clear Memory Mode and Inspection Mode .


WIRING DIAGRAM:


CHECK INPUT SIGNAL FOR ECM.

Turn the ignition switch to OFF.

Measure the voltage between ECM connector and chassis ground.

Connector & terminal

(B137) No. 13 (+) — Chassis ground (−):

Is the voltage more than 8 V?

Yes


No


CHECK CURRENT DATA.

Repair the battery short circuit in harness between ECM and rear oxygen sensor connector.

Turn the ignition switch to ON.

Read the data of rear oxygen sensor heater current using Vehicle Diagnostic Interface or the OBD-II general scan tool.

Note
• Vehicle Diagnostic Interface

For detailed operation procedure, refer to the “READ CURRENT DATA FOR ENGINE”.

• OBD-II general scan tool

For detailed operation procedure, refer to the OBD-II General Scan Tool Instruction Manual.


Is the current more than 7 A?

Yes

Replace the ECM.


No

END


CHECK POOR CONTACT.

Check poor contact in ECM connector.

Is there poor contact in ECM connector?

Yes

Repair the poor contact in ECM connector.


No

END