SAAB WIS ONLINE

DTC P1152 O2 SENSOR CIRCUIT RANGE/PERFORMANCE (LOW) (BANK1 SENSOR1)

DTC P1152 O 2 SENSOR CIRCUIT RANGE/PERFORMANCE (LOW) (BANK1 SENSOR1)

DTC DETECTING CONDITION:


Two consecutive driving cycles with fault

GENERAL DESCRIPTION


Important

After repair or replacement of faulty parts, conduct Clear Memory Mode and Inspection Mode .


WIRING DIAGRAM:


CHECK HARNESS BETWEEN ECM AND FRONT OXYGEN (A/F) SENSOR CONNECTOR.

Turn the ignition switch to OFF.

Disconnect the connectors from ECM and front oxygen (A/F) sensor connector.

Measure the resistance of harness between ECM and front oxygen (A/F) sensor connector.

Connector & terminal

(B134) No. 26 — (E47) No. 2:

(B134) No. 33 — (E47) No. 1:

Is the measured value less than 1 Ω?

Yes


No

Repair the harness and connector.

Note

In this case, repair the following:

Open circuit in harness between ECM and front oxygen (A/F) sensor connector

Poor contact in front oxygen (A/F) sensor connector

Poor contact in ECM connector



CHECK POOR CONTACT.

Check poor contact in front oxygen (A/F) sensor connector.

Is there poor contact in front oxygen (A/F) sensor connector?

Yes

Repair the poor contact in front oxygen (A/F) sensor connector.


No

Replace the front oxygen (A/F) sensor.