INSTALLATION

INSTALLATION

Secure the oil pump housing with two nuts and a bolt.

Tightening torque:

42 Nm (4.3 kgf-m, 31 ft-lb)

(A)	Oil pump housing

Install the converter case assembly to the transmission case assembly.

Install reduction driven gear.

Install the reduction drive gear. (MPT model)

Install the center differential carrier. (VTD model)

Combine the extension case with the transmission case, and install vehicle speed sensor 1 (rear).

Insert inhibitor switch and transmission connector into stay.

(A)	Transmission harness
(B)	Inhibitor switch harness

Install the oil cooler pipe.

Install the oil charge pipe with O-ring.

Insert the input shaft while turning lightly by hand and verify the protrusion amount.

Normal protrusion A:

50 — 55 mm (1.97 — 2.17 in)

Install the torque converter clutch assembly.

Install the transmission assembly to the vehicle.