Compressor clutch, To remove and To fit, Z18XE
|
Compressor clutch, To remove and To fit, Z18XE
|
Important:
The compressor belt pulley and the compressor clutch must be replaced together during a replacement. The service department delivers these parts as a set.
3.
|
Remove the compressor clutch (1):
Instructions: Secure the compressor using protective jaws on the holder in a screw vice
- Unscrew nut (2) - hold still with MKM-6319-1 (3)
- Pull the compressor clutch away upwards (4)
- Remove the spacer
|
1.
|
Fit the compressor clutch:
- Fit the spacer. Instructions: Re-use removed spacers.
- Fit the compressor clutch. Tighten nut (20 Nm) - hold still with MKM-6319-1 (3)
|
2.
|
Adjust the compressor clutch's clearance:
- Check the clearance of the compressor clutch. Desired value: 0.3 - 0.7 mm
Instructions: Check the gap between clutch (2) and the friction surface of the belt pulley (3) at 4 points (indicated with arrows) using a feeler gauge (1). Calculate the mean value.
- Correct the gap measurement. Instructions: add or remove spacers (4)
|