SAAB WIS ONLINE

DTC P2534 (Fuel Pump Control Module)

DTC P2534 (Fuel Pump Control Module)

Diagnostic Instructions


Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

Review Strategy Based Diagnosis for an overview of the diagnostic approach.

Diagnostic Procedure Instructions provides an overview of each diagnostic category.


DTC Descriptor

DTC P2534

Ignition 1 Switch Circuit Low Voltage

Diagnostic Fault Information

Circuit Short to Ground Open or High Resistance Short to Voltage Signal Performance
IGN Voltage P2534 P2534 - -


Circuit/System Description

The fuel pump control module monitors the ignition voltage circuit in order to determine if the voltage is within the normal operating range.

Conditions for Running the DTC

Engine is running.

Conditions for Setting the DTC

The FPCM detects that the IGN voltage is less than 6.0 V.

Action Taken When the DTC Sets

DTC P2534 is a Type A DTC.

Conditions for Clearing the DTC

DTC P2534 is a Type A DTC.

Reference Information

Schematic Reference

Engine Controls Schematics (3.0L (LF1)) Engine Controls Schematics (2.8L (LAU))

Connector End View Reference

Component Connector End Views

Description and Operation

Fuel System Description (LF1) Fuel System Description (LAU or LY7)

Electrical Information Reference


Circuit Testing

Connector Repairs

Testing for Intermittent Conditions and Poor Connections

Wiring Repairs


DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Scan Tool Reference

Control Module References for scan tool information

Circuit/System Testing


1. Verify that DTC P0562 is not set.

2. If DTC P0562 is set, refer to Diagnostic Trouble Code (DTC) List - Vehicle .

3. Ignition OFF, disconnect the harness connector of the K27 fuel pump control module.

4. Ignition ON, verify that a test lamp illuminates between the ignition circuit terminal 21 and ground.

5. If the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance.

6. If all circuits test normal, replace the K27 fuel pump control module.


Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for fuel pump control module replacement, setup, and programming