SAAB WIS ONLINE

Cruise Control Malfunction

Cruise Control Malfunction

Diagnostic Instructions


Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

Review Strategy Based Diagnosis for an overview of the diagnostic approach.

Diagnostic Procedure Instructions provides an overview of each diagnostic category.


Diagnostic Fault Information

Circuit Short to Ground Open or High Resistance Short to Voltage Signal Performance
B+ 1 1 1 -
Cruise Control Switch Signal 1 P0564 B3794 08, P0567, P0568 B3794 61, P0564
1. Cruise Control Malfunction


Circuit/System Description

The cruise control switch is an input to the body control module (BCM). The BCM monitors the cruise control on/off, set/coast, resume/accelerate and cancel switches via the cruise control switch signal circuit in order to detect when the driver has requested to perform a cruise control function. The BCM detects a specific voltage signal on the cruise control switch signal circuit when a switch is applied. The BCM sends a serial data message to the engine control module (ECM) indicating the status of the cruise control switches.

Reference Information

Schematic Reference

Cruise Control Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Cruise Control Description and Operation

Electrical Information Reference


Circuit Testing

Connector Repairs

Testing for Intermittent Conditions and Poor Connections

Wiring Repairs


Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification

Engine ON, while rotating the steering wheel to both steering stops, observe the scan tool Cruise Control Switch parameter while pressing each of the cruise control switches. The parameter should toggle between On, Off, Resume, Set, and Cancel as the applicable switch is pressed.

Circuit/System Testing


1. Ignition OFF, disconnect the harness connector at the S70R steering wheel control switch-right.

2. Ignition ON, test for B+ between the B+ circuit terminal 1 and ground.

3. If less than the specified value, test the circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K9 BCM.

4. Test for B+ between the B+ circuit terminal 1 and the signal circuit terminal 3.

5. If less than the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the K9 BCM.

6. Ignition OFF, disconnect the X1 harness connector at the K9 BCM.

7. Test for infinite resistance between the signal circuit terminal 9 and ground.

8. If less than the specified value, test the signal circuit for a short to ground.

9. If all circuits test normal, test or replace the S70R steering wheel control switch-right.


Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.


Cruise Control Switch Replacement

Control Module References for BCM control module replacement, programming and setup