SAAB WIS ONLINE

DTC B3607

DTC B3607

Diagnostic Instructions


• Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

• Review Strategy Based Diagnosis for an overview of the diagnostic approach.

• Diagnostic Procedure Instructions provides an overview of each diagnostic category.


DTC Descriptor

DTC B3607 4B

Adjustable Pedal Motor Circuit Calibration Not Learned

Circuit/System Description

After replacement of adjustable pedal mechanical components or if the memory seat control module is reprogrammed or replaced, the adjustable pedals softstop positions must be learned.

Conditions for Running the DTC

The memory seat control module must be powered.

Conditions for Setting the DTC

This DTC will set if the pedals actuator softstops are not learned.

Action Taken When the DTC Sets

Manual and memory adjustable pedals operation will be disabled.

Conditions for Clearing the DTC


• The current DTC will become a history DTC when the fault is no longer present and the ignition has been cycled.

• The history DTC will clear after 50 consecutive fault-free ignition cycles have occurred.


Reference Information

Schematic Reference

Adjustable Pedal Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Adjustable Pedals Description and Operation

Electrical Information Reference


• Circuit Testing

• Connector Repairs

• Testing for Intermittent Conditions and Poor Connections

• Wiring Repairs


Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification


1. Ignition ON, verify that no other adjustable pedal DTCs are set.

2. If other adjustable pedal DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle .

3. Observe the scan tool Adjustable Pedals Softstop Learn Status parameter. The parameter reading should be learned.

4. If not the specified value, perform the scan tool Learn Adjustable Pedals Softstops procedure. Refer to Adjustable Pedal System Calibration . If the DTC resets, replace the K40 memory seat control module.


Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for memory seat control module replacement, setup, and programming