Instrument Cluster Gauges Inoperative
|
Instrument Cluster Gauges Inoperative
|
Circuit/System Description
|
The instrument cluster displays the engine coolant temperature, fuel level, vehicle speed and the engine speed based on the information from the engine control module (ECM). The ECM sends information via a High Speed CAN-Bus signal to the body control module (BCM). The BCM then sends the information via a Low Speed CAN-Bus signal to the instrument cluster to display the engine coolant temperature, fuel level, the engine speed, the vehicle speed and the distance travelled, either in kilometers or miles, based on the vehicle requirements.
Schematic Reference
Instrument Cluster Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Instrument Cluster Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References
for scan tool information
Circuit/System Verification
|
2.
|
If any DTC is set, diagnose this first.
|
3.
|
Ignition ON, perform the Instrument Cluster Gauge Sweep test with the scan tool, verify that all gauges sweep from their low to high position.
|
4.
|
If any gauge does not sweep, replace the P16 Instrument Cluster.
|
5.
|
Drive the vehicle, verify the gauge values matches the values on the scan tool.
|
6.
|
If the values do not match, replace the P16 Instrument Cluster .
|
7.
|
If all gauges do sweep and display the correct value, and the odometer display counts up, replace the K20 Engine Control Module.
|
Perform the
Diagnostic Repair Verification
after completing the diagnostic procedure.
Control Module References
for instrument cluster or ECM replacement, setup and programming