DTC B0655
DTC B0655 |
Diagnostic Instructions |
• |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
• |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
• |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
DTC Descriptor |
DTC B0655 5A
Brake Lamp Switch Circuit Not Plausible
Diagnostic Fault Information |
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
Center High Mounted Brake Lamp Control | B3884 02 | B3884 04 | 1 | B0655 5A |
1. Center High Mounted Brake Lamp Always ON |
Circuit/System Description |
The brake pedal position sensor is used to sense the action of the driver application of the brake pedal. The brake pedal position sensor provides an analog voltage signal to the body control module (BCM). The BCM will apply battery voltage to the right, left and center stop lamp control circuits and to the trailer brake control module if equipped.
Conditions for Running the DTC |
When the brake pedal is applied.
Conditions for Setting the DTC |
The trailer brake control module receives a serial data message from the BCM that the brakes have been applied, but the trailer brake control module does not detect a signal voltage on the center high mounted stop lamp control circuit.
Action Taken When the DTC Sets |
The brake lights on the trailer will be inoperative
Conditions for Clearing the DTC |
• |
The DTC will be current for as long as the fault is present.
|
• |
When the fault is no longer present, the DTC will be a history DTC.
|
• |
A history DTC will clear after 50 ignition cycles.
|
Reference Information |
Schematic Reference
Trailer Connector/Provision Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Exterior Lighting Systems Description and Operation
Electrical Information Reference
• |
Circuit Testing
|
• |
Connector Repairs
|
• |
Testing for Intermittent Conditions and Poor Connections
|
• |
Wiring Repairs
|
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification |
Observe the function of the E6 center high mounted stop lamp while pressing and releasing the brake pedal. The E6 center high mounted stop lamp should turn ON when the pedal is pressed and OFF when the pedal is released.
Circuit/System Testing |
1. |
Ignition OFF, disconnect the X1 harness connector at the K67 trailer brake control module.
|
2. |
Connect a test lamp between the signal circuit terminal 14 and ground.
|
3. |
Ignition ON, command the Center Brake Lamp ON and OFF with a scan tool. The test lamp should turn ON and OFF while changing between the commanded states.
|
4. |
If the test lamp is always ON, test the signal circuit for a short to voltage.
|
5. |
If the test lamp is always OFF, test the signal circuit for a short to ground or an open/high resistance.
|
6. |
If all circuits test normal, replace the K67 trailer brake control module.
|
Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for trailer brake control module replacement, programming and setup