SAAB WIS ONLINE

DTC B2615

DTC B2615

Diagnostic Instructions


• Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

• Review Strategy Based Diagnosis for an overview of the diagnostic approach.

• Diagnostic Procedure Instructions provides an overview of each diagnostic category.


DTC Descriptor

DTC B2615 02

Passenger Compartment Dimming 2 Circuit Short to Ground

Diagnostic Fault Information

Circuit Short to Ground Open/High Resistance Short to Voltage Signal Performance
Courtesy Lamps Control B2615 02 2 1 -
1. Courtesy Lamps Always Illuminated 2. Courtesy Lamps do Not Illuminate


Circuit/System Description

Battery voltage for the courtesy lamps is supplied at all times to the body control module (BCM). When the BCM receives a signal to command the courtesy lamps ON, it then applies voltage through the courtesy lamps control circuits to the courtesy lamps.

Conditions for Running the DTC

The BCM attempts to illuminate the courtesy lamps.

Conditions for Setting the DTC

The BCM detects a short to ground on the courtesy lamp control circuit.

Action Taken When the DTC Sets

The BCM will not attempt to activate courtesy lamps.

Conditions for Clearing the DTC


• The condition responsible for setting the DTC no longer exists.

• A history DTC will clear once 100 consecutive malfunction ignition cycles have occurred.


Reference Information

Schematic Reference

Interior Lights Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Interior Lighting Systems Description and Operation

Electrical Information Reference


• Circuit Testing

• Connector Repairs

• Testing for Intermittent Conditions and Poor Connections

• Wiring Repairs


Scan Tool Reference

Control Module References

Circuit/System Verification

Command the Courtesy Lamps ON and OFF with a scan tool. The courtesy lamps should turn ON and OFF when changing between commanded states.

Circuit/System Testing


1. Disconnect the harness connector at the appropriate courtesy lamp.

2. Ignition OFF, scan tool OFF, doors CLOSED, interior lamps OFF, test for less than 5.0 Ω between the ground circuit terminal listed below and ground:

• Instrument Panel Courtesy Lamp - terminal 2

• Door Courtesy Lamp - terminal 2

• Overhead Console Courtesy/Reading Lamp - terminal 2

• Rear Courtesy/Reading Lamp - terminal B

3. If greater than the specified range, test the ground circuit for an open/high resistance.

4. Connect a test lamp between the control circuit terminal listed below and ground:

• Instrument Panel Courtesy Lamp - terminal 1

• Door Courtesy Lamp - terminal 1

• Overhead Console Courtesy/Reading Lamp - terminal 3

• Rear Courtesy/Reading Lamp - terminal C

5. Command the Courtesy Lamps ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.

6. If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K9 BCM.

7. If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the K9 BCM.

8. If all circuits test normal, replace the courtesy lamp.


Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic repair.


• Refer to the appropriate replacement procedure for the lighting component that requires replacement.

• Control Module References for BCM replacement, programming and setup