Hazard Lamps Malfunction
Hazard Lamps Malfunction |
Diagnostic Instructions |
• |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
• |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
• |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
Diagnostic Fault Information |
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
Hazard Switch Signal | B3596 00 | 1 | 1 | - |
1. Hazard Function Inoperative |
Circuit/System Description |
When the hazard switch is placed in the ON position, ground is momentarily applied through the hazard switch signal circuit to the body control module (BCM). The BCM will detect this voltage drop and will supply battery voltage to all four turn signal lamps in an ON and OFF duty cycle. When the hazard switch is activated, the BCM sends a serial data message to the instrument panel cluster (IPC) requesting both turn signal indicators to be cycled ON and OFF.
Reference Information |
Schematic Reference
Exterior Lights Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Exterior Lighting Systems Description and Operation
Electrical Information Reference
• |
Circuit Testing
|
• |
Connector Repairs
|
• |
Testing for Intermittent Conditions and Poor Connections
|
• |
Wiring Repairs
|
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification |
Observe the function of the right and left turn signal lamps while turning the hazard lamp switch ON and OFF. The right and left turn signal lamps should cycle ON and OFF while the hazard lamp switch is ON and remain OFF when the hazard lamp switch is OFF.
Circuit/System Testing |
1. |
Ignition OFF, disconnect the harness connector at the P17 info display module.
|
2. |
Ignition ON, test for greater than 10V between the signal circuit terminal 16 and ground.
|
3. |
If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K9 BCM.
|
4. |
If all circuits test normal, replace the P17 info display module.
|
Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
• |
Radio Control Assembly Replacement
|
• |
Control Module References
for BCM replacement, setup, and programming
|