DTC B3697
DTC B3697 |
Diagnostic Instructions |
• |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
• |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
• |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
DTC Descriptors |
DTC B3697 00
Sunroof Actuator Malfunction
DTC B3697 39
Sunroof Actuator Internal Malfunction
DTC B3697 42
Sunroof Actuator Calibration Not Programmed
DTC B3697 4B
Sunroof Actuator Calibration Not Learned
Circuit/System Description |
The sunroof glass is controlled by its own integrated motor/controller containing the necessary electronics, motor, hall effect position sensors, as well as the interface to the driver control switches. The motor/controller is capable of controlling motion based on control switch activation and LIN-Bus message commands from the body control module (BCM).
Conditions for Running the DTC |
The ignition is ON.
Conditions for Setting the DTC |
B3697 00
The sunroof module has detected and reported via the LIN-Bus that the sunroof actuator has a malfunction.B3697 39
The sunroof module has detected and reported via the LIN-Bus that the sunroof actuator has a internal malfunction.B3697 42
The sunroof module has detected and reported via the LIN-Bus that the sunroof actuator is not programmed.B3697 4B
The sunroof module has detected and reported via the LIN-Bus that the sunroof actuator calibration is not learned.Action Taken When the DTC Sets |
DTC B3697 is stored in the BCM memory.
Conditions for Clearing the DTC |
The BCM no longer detects a malfunction in the sunroof actuator.
Reference Information |
Schematic Reference
Sunroof Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Sunroof Description and Operation
Electrical Information Reference
• |
Circuit Testing
|
• |
Connector Repairs
|
• |
Testing for Intermittent Conditions and Poor Connections
|
• |
Wiring Repairs
|
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification |
1. |
Verify that DTC B3697 42 or DTC B3697 4B is not set.
|
2. |
If the DTC is set, program or calibrate the K61 sunroof control module. If the DTC resets, replace the K61 sunroof control module.
|
3. |
Replace the K61 sunroof control module.
|
Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for sunroof motor/actuator replacement, programming and setup