DTC P003A (LBY)
DTC P003A (LBY) |
Diagnostic Instructions |
• |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
• |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
• |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
DTC Descriptor |
DTC P003A 00
Turbocharger 1 Boost Control Position Not Learned
Circuit/System Description |
The engine control module (ECM) performs the turbocharger learn procedure automatically when the enabling criteria have been met. After each ignition cycle, and before the enable criteria have been met, the ECM will use the previously learned value. If the ECM does not have a previously learned value, it will default to a stored calibrated value.
The ECM varies the boost dependant upon the load requirements of the engine.
Conditions for Running the DTC |
• |
The battery voltage is equal to or greater than 11 V.
|
• |
The engine speed is between 750-850 RPM.
|
• |
The engine coolant temperature (ECT) is between 73-96°C (163-205°F).
|
• |
DTCs P003A or P003B runs once per key cycle when the above conditions are met.
|
Conditions for Setting the DTC |
• |
The engine control module (ECM) determines that the difference between the desired boost pressure actuator and the actual boost pressure actuator exceed a calibrated threshold during a valid learn event.
|
• |
The above condition is met.
|
Action Taken When the DTC Sets |
DTCs P003A and P003B are Type C DTCs.
Conditions for Clearing the DTC |
DTCs P003A and P003B are Type C DTCs.
Diagnostic Aids |
If any service has been performed on the turbocharger or on the turbocharger components, a turbocharger relearn must be performed. Failure to perform the turbocharger learn procedure may cause other DTCs to set.
The turbocharger learn procedure is required when the following service procedures have been performed:
• |
Boost Pressure Actuator LPT replacement
|
• |
Boost Pressure Actuator HPT replacement
|
• |
ECM replacement
|
• |
Turbocharger replacement
|
• |
Any service that disturbs the turbocharger components
|
Reference Information |
Schematic Reference
Engine Controls Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Turbocharger System Description
Electrical Information Reference
• |
Circuit Testing
|
• |
Connector Repairs
|
• |
Testing for Intermittent Conditions and Poor Connections
|
• |
Wiring Repairs
|
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification |
Note | ||
Once the enable conditions have been met the throttle must remain at idle. Do not change the accelerator pedal position (APP) during this procedure. |
1. |
The following conditions must be met for the ECM to perform the turbocharger learn procedure:
|
• |
The A/C is OFF.
|
• |
The vehicle is in Park or Neutral.
|
• |
Start and run the engine.
|
• |
The ECT is greater than 40°C (104°F).
|
2. |
Perform the Turbocharger Learn procedure. Refer to
Control Module References
.
|
3. |
Verify the DTC does not reset.
|
4. |
If the DTC resets, replace the K20 Engine Control Module.
|
Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for Engine Control Module replacement, setup, and programming