Odometer Trip/Reset Switch Inoperative
Odometer Trip/Reset Switch Inoperative |
Diagnostic Instructions |
• |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
• |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
• |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
Circuit/System Description |
The instrument cluster displays the traveled distance based on the information from the engine control module (ECM). The ECM converts the data from the vehicle speed sensor to a distance signal. The ECM sends the distance information via a High Speed CAN-Bus signal to the body control module (BCM). The BCM then sends the information via a Low Speed CAN-Bus signal to the instrument cluster to display the vehicle odometer and trip odometer. The instrument cluster detects activation of the trip reset switch. The trip meter's information is reset to zero by holding down the trip reset switch.
Reference Information |
Schematic Reference
Instrument Cluster Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Instrument Cluster Description and Operation
Electrical Information Reference
• |
Circuit Testing
|
• |
Connector Repairs
|
• |
Testing for Intermittent Conditions and Poor Connections
|
• |
Wiring Repairs
|
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification |
Ignition ON, verify the odometer trip reset switch resets the trip odometer display when the switch is pressed.
Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for instrument cluster replacement, setup and programming