DTC B096F
DTC B096F |
Diagnostic Instructions |
• |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
• |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
• |
Diagnostic Procedure Instructions
has overviews of all diagnostic categories.
|
DTC Descriptors |
DTC B096F 01
Power Mode Switch Assembly Backlight Circuit Short to Battery
DTC B096F 02
Power Mode Switch Assembly Backlight Circuit Short to Ground
DTC B096F 04
Power Mode Switch Assembly Backlight Circuit Open
Diagnostic Fault Information |
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
Power Mode Switch Assembly Backlight Control
|
B096F 02
|
B096F 04
|
B096F 01
|
-
|
Circuit/System Description |
The body control module (BCM) supplies a pulse width modulated (PWM) voltage to the LED circuit of the power mode for backlight.
Conditions for Running the DTC |
The ignition is ON.
Conditions for Setting the DTC |
The BCM detects a short to voltage, short to ground, or an open in the PWM circuit for the power mode switch backlight LED circuit.
Action Taken When the DTC Sets |
The BCM will not illuminate the LED backlighting supplied by the backlight lamp control circuit.
Conditions for Clearing the DTC |
• |
The condition responsible for setting the DTC no longer exists.
|
• |
A history DTC will clear once 100 consecutive malfunction ignition cycles have occurred.
|
Reference Information |
Schematic Reference
Exterior Lights Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Interior Lighting Systems Description and Operation
Electrical Information Reference
• |
Circuit Testing
|
• |
Connector Repairs
|
• |
Testing for Intermittent Conditions and Poor Connections
|
• |
Wiring Repairs
|
Scan Tool Reference
Control Module References for information on diagnostic tools
Circuit/System Verification |
Open the drivers door and observe the power mode switch. The power mode switch backlight should be illuminated.
Circuit/System Testing |
1. |
Disconnect the harness connector at the S38 Ignition Mode Switch.
|
2. |
Test for less than 5 Ω between the ground circuit terminal 4 and ground.
|
3. |
If greater than the specified range, test the ground circuit for an open/high resistance.
|
4. |
Connect a test lamp between the backlight control circuit of S38 Ignition Mode Switch terminal 8 and ground.
|
5. |
Close the driver's door and wait 30 seconds. Open the driver's door and check that the test lamp blinks.
|
6. |
If the test lamp does not flash, test the control circuit for an open/high resistance or short to ground. If the circuit tests normal, replace the K9 Body Control Module.
|
7. |
If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the K9 Body Control Module.
|
8. |
If all circuits test normal, replace the S38 Ignition Mode Switch.
|
Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
• |
Ignition and Start Switch Replacement
|
• |
Control Module References
for information on BCM replacement, setup, and programming
|