DTC B2570
DTC B2570 |
Diagnostic Instructions |
• |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
• |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
• |
Diagnostic Procedure Instructions
has overviews of all diagnostic categories.
|
DTC Descriptor |
DTC B2570 02
Trunk Lamp Control Circuit Short to Ground
Diagnostic Fault Information |
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
Trunk Lamp Control
|
B2570 02
|
1
|
2
|
-
|
Ground
|
-
|
1
|
1
|
-
|
1. Rear Compartment Lamps Inoperative
2. Rear Compartment Lamps Always ON |
Circuit/System Description |
When the body control module (BCM) receives a trunk open signal, the BCM supplies B+ to the trunk lamp control circuit. This will illuminate the rear compartment lamps.
Conditions for Running the DTC |
The trunk is in open position.
Conditions for Setting the DTC |
The BCM detects a short to ground on the trunk lamp control circuits.
Action Taken When the DTC Sets |
The rear compartment lamp is OFF.
Conditions for Clearing the DTC |
The condition responsible for setting the DTC no longer exists.
Reference Information |
Schematic Reference
Interior Lights Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Interior Lighting Systems Description and Operation
Electrical Information Reference
• |
Circuit Testing
|
• |
Connector Repairs
|
• |
Testing for Intermittent Conditions and Poor Connections
|
• |
Wiring Repairs
|
Scan Tool Reference
Control Module References for information on diagnostic tools
Circuit/System Verification |
Command the Trunk Lamp Duty Cycle test ON and OFF with a scan tool. The rear compartment lamps should be ON and OFF.
Circuit/System Testing |
1. |
Ignition OFF, disconnect the harness connector at the E8E Rear Compartment Courtesy Lamp - Left or E8F Rear Compartment Courtesy Lamp - Right.
|
2. |
Test for less than 5 Ω between the ground circuit terminal 2 and ground.
|
3. |
If greater than the specified range, test the ground circuit for an open/high resistance.
|
4. |
Connect a test lamp between the E8E Rear Compartment Courtesy Lamp - Left or E8F Rear Compartment Courtesy Lamp - Right and ground.
|
5. |
Command the Trunk Lamp Duty Cycle test ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.
|
6. |
If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the K9 Body Control Module.
|
7. |
If the test lamp is always OFF, test the control circuit for a short to round or open/high resistance. If the circuit tests normal, replace the K9 Body Control Module.
|
8. |
If the all circuits test normal, replace the E8E Rear Compartment Courtesy Lamp - Left or E8F Rear Compartment Courtesy Lamp - Right.
|
Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
• |
Rear Compartment Courtesy Lamp Replacement
|
• |
Control Module References
for BCM control module replacement setup and programming
|