Glove Box Illumination Malfunction
Glove Box Illumination Malfunction |
Diagnostic Instructions |
• |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
• |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
• |
Diagnostic Procedure Instructions
has overviews of all diagnostic categories.
|
Diagnostic Fault Information |
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
Instrument Panel Compartment Lamp B+
|
1, 2, 3
|
3
|
-
|
-
|
Instrument Panel Compartment Lamp Ground
|
-
|
3
|
-
|
-
|
1. Reading Lamps Always OFF
2. Sunshade Lamps Always OFF 3. Instrument Panel Compartment Lamp Always OFF |
Circuit/System Description |
The body control module (BCM) supplies the dome/reading lamps, sunshade and instrument panel compartment lamp with battery voltage. When switching on the following components the concerning lamps will illuminate:
• |
Dome/reading lamps
|
• |
Dome/reading lamps row
|
• |
Sunshade left Front
|
• |
Sunshade right Front
|
• |
Instrument panel compartment lamp
|
Reference Information |
Schematic Reference
Interior Lights Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Interior Lighting Systems Description and Operation
Electrical Information Reference
• |
Circuit Testing
|
• |
Connector Repairs
|
• |
Testing for Intermittent Conditions and Poor Connections
|
• |
Wiring Repairs
|
Scan Tool Reference
Control Module References for information on diagnostic tools
Circuit/System Verification |
Ignition ON, observe lamp of the instrument panel compartment while opening the glove box. The lamp should illuminate when opened.
Circuit/System Testing |
Instrument Panel Compartment Lamp Circuit Malfunction
1. |
Ignition OFF, disconnect the harness connector at the E27 Instrument Panel Compartment Lamp.
|
2. |
Test for less than 5 Ω between the ground circuit terminal 2 and ground.
|
3. |
If greater than the specified range, test the ground circuit for an open/high resistance.
|
4. |
Ignition ON, test for greater than 11 V between the 12 V reference circuit terminal 1 and ground.
|
5. |
If less than the specified value, test the circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K9 Body Control Module.
|
6. |
If all circuits test normal, test or replace the E27 Instrument Panel Compartment Lamp.
|
Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
• |
Instrument Panel Compartment Lamp Replacement
|
• |
Control Module References
for information on BCM replacement, setup, and programming
|