DTC B096B
DTC B096B |
Diagnostic Instructions |
• |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
• |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
• |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
DTC Descriptor |
DTC B096B 02
Parking Aid Switch Parallel Parking Circuit Short to Ground
Diagnostic Fault Information |
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
Parallel Park Assist Switch Signal
|
B096B 02
|
1
|
-
|
-
|
Parallel Parking Assist Switch Ground
|
-
|
1
|
-
|
-
|
1. Parallel Parking Assist Switch Malfunction
|
Circuit/System Description |
The parallel parking assist can be activated/deactivated by pressing the parallel parking assist switch.
Conditions for Running the DTC |
• |
Ignition ON
|
• |
The parallel parking assist is activated. The activation takes place through pressing the parallel parking assist switch.
|
Conditions for Setting the DTC |
The parking assist control module has detected a short to ground.
Action Taken When the DTC Sets |
• |
The parallel parking assist is disabled.
|
• |
An indicator in the driver information center shows the parking assistance is not available.
|
Conditions for Clearing the DTC |
The condition for setting the DTC is no longer present.
Reference Information |
Schematic Reference
Object Detection Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Object Detection Description and Operation (Parking Assist) Object Detection Description and Operation (Lane Departure Warning) Object Detection Description and Operation (Parking Assist with Parallel Parking) Object Detection Description and Operation (Traffic Sign Assist)
Electrical Information Reference
• |
Circuit Testing
|
• |
Connector Repairs
|
• |
Testing for Intermittent Conditions and Poor Connections
|
• |
Wiring Repairs
|
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification |
Activate and deactivate the parallel park assist switch and verify the scan tool Advanced Park Assist Switch parameter changes between Active and Inactive.
Circuit/System Testing |
1. |
Ignition OFF, disconnect the X2 harness connector at the K41 Parking Assist Control Module.
|
2. |
Test for infinite resistance between the input signal circuit terminal 6 X2 at the K41 Parking Assist Control Module harness connector and ground.
|
3. |
If less than the specified range, test input signal circuit for a short to ground. If the circuit tests normal, replace the S48E Multifunction Switch - Center Console.
|
4. |
If all circuits test normal, replace the K41 Parking Assist Control Module.
|
Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
• |
Front Floor Console Multifunction Switch Replacement
|
• |
Control Module References
for parking assist control module replacement, setup and programming
|