DTC B356A
DTC B356A |
Diagnostic Instructions |
• |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
• |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
• |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
DTC Descriptors |
DTC B356A 02
Vehicle Direction Warning Switch Circuit Short to Ground
DTC B356A 05
Vehicle Direction Warning Switch Circuit High Voltage/Open
Diagnostic Fault Information |
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
Lane Departure Warning Switch Signal
|
B356A 02
|
B356A 05
|
B356A 05
|
-
|
Lane Departure Warning Switch Ground
|
-
|
B356A 05
|
-
|
-
|
Circuit/System Description |
The lane departure warning is enabled and disabled through a switch located in the multifunction switch at the centre console. When enabled, the vehicle direction camera control module will illuminate the indicator located in the switch.
Conditions for Running the DTC |
Ignition ON
Conditions for Setting the DTC |
B356A 02
The vehicle direction camera control module has detected a short to ground or closed for more than 20 s.B356A 05
The vehicle direction camera control module has detected a short to battery or open.Action Taken When the DTC Sets |
• |
Lane departure warning is disabled.
|
• |
SERVICE LANE DEPARTURE SYSTEM is displayed on the driver information center.
|
Conditions for Clearing the DTC |
The condition for setting the DTC is no longer present.
Reference Information |
Schematic Reference
Object Detection Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Object Detection Description and Operation (Parking Assist) Object Detection Description and Operation (Lane Departure Warning) Object Detection Description and Operation (Parking Assist with Parallel Parking) Object Detection Description and Operation (Traffic Sign Assist)
Electrical Information Reference
• |
Circuit Testing
|
• |
Connector Repairs
|
• |
Testing for Intermittent Conditions and Poor Connections
|
• |
Wiring Repairs
|
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification |
Ignition ON, observe the scan tool Vehicle Direction Camera Switch Status parameter while pressing and releasing the lane departure warning switch. The parameter should change between Open and Closed.
Circuit/System Testing |
1. |
Ignition OFF, disconnect the harness connector at the S48E Multifunction Switch - Centre Console
|
2. |
Test for less than 10 Ω between the S48E Multifunction Switch 2 - multifunction switch, centre console, ground circuit terminal 2 and ground.
|
3. |
If greater than the specified range, test the ground circuit for an open/high resistance.
|
4. |
Ignition ON, verify the scan tool Vehicle Direction Camera Switch Status parameter is Open.
|
5. |
If not the specified value, test the signal circuit terminal 7 for a short to ground. If the circuit tests normal, replace the K74 Vehicle Direction Camera Control Module.
|
6. |
Install a 3 A fused jumper wire between the signal circuit terminal 7 and ground circuit terminal 2. Verify the scan tool Vehicle Direction Camera Switch Status parameter is Closed.
|
7. |
If not the specified value, test the signal circuit terminal for a short to battery or an open/high resistance. If the circuit tests normal, replace the K74 Vehicle Direction Camera Control Module.
|
8. |
If all circuits test normal, replace the S48E Multifunction Switch - Centre Console.
|
Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
• |
Front Floor Console Multifunction Switch Replacement
|
• |
Control Module References
for vehicle direction camera control module replacement, setup and programming
|