DTC P1649
DTC P1649 |
Diagnostic Instructions |
• |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
• |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
• |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
DTC Descriptor |
DTC P1649
Immobilizer Security Code Not Programmed
Circuit/System Description |
When learning the security code, as well as the challenge and response sequence, the engine control module (ECM) is placed in learn mode. Once the security code and challenge/response are learned, learn mode will be exited when the engine is successfully started.
Conditions for Running the DTC |
The ECM is in learn mode.
Conditions for Setting the DTC |
The ECM is not programmed.
Action Taken When the DTC Sets |
The security indicator in the instrument cluster will be illuminated.
Conditions for Clearing the DTC |
• |
A current DTC P1649 will be cleared upon a successful engine start after exit of learn mode.
|
• |
A history DTC will be cleared after 100 malfunction-free ignition cycles or when a scan tool is used to clear DTCs.
|
Reference Information |
Schematic Reference
Immobilizer Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Immobilizer Description and Operation
Electrical Information Reference
• |
Circuit Testing
|
• |
Connector Repairs
|
• |
Testing for Intermittent Conditions and Poor Connections
|
• |
Wiring Repairs
|
Scan Tool Reference
Control Module References
Circuit/System Verification |
Note | ||
Because of normal system communications between the BCM and ECM, any immobilizer B-codes must be diagnosed prior to the diagnosis of P-codes. |
Perform the Immobilizer Relearn procedure. Refer to Immobilizer System Component Programming .
Repair Instructions |
Perform the Diagnostic Repair Verification .
Control Module References
For P-codes refer to Diagnostic Trouble Code (DTC) List - Vehicle .