SAAB WIS ONLINE

Differential Carrier Assembly Replacement

Differential Carrier Assembly Replacement



Callout Component Name

Preliminary Procedure

1. Remove the muffler. Refer to Exhaust Muffler Replacement (LAU/A28NER) Exhaust Muffler Replacement (LBS/A20DTH) Exhaust Muffler Replacement (Spare part) .

2. Remove the propeller shaft. Refer to Propeller Shaft Replacement .

3. Remove both rear wheel drive shafts. Refer to Rear Wheel Drive Shaft Replacement .

4. Remove the bushing bolts and move aside the stabilizer shaft. Refer to Stabilizer Shaft Replacement (GNC) Stabilizer Shaft Replacement (GNE FWD) .


1

Rear Axle Assembly Fasteners (Qty: 4)

Warning

To prevent personal injury and/or component damage, support the differential case when removing the case from the axle housing. If the case is not supported, the differential case could fall and cause personal injury or damage to the differential case.


Refer to Fastener Caution .


Procedures

1. Support with a column jack.

2. Secure with cable ties.

3. Install new bolts.


Tighten

90 Nm. (66 lb ft) + 90 degrees + 15 degrees

2

Differential Carrier:


Procedures

1. Check the level in the rear axle. Refer to Rear Axle Lubricant Level Inspection

2. Fill rear axle oil. Refer to Differential Oil Replacement