SAAB WIS ONLINE

Rear Differential Clutch Control Module Replacement

Rear Differential Clutch Control Module Replacement



Callout Component Name

Preliminary Procedure

1. Remove the muffler. Refer to Exhaust Muffler Replacement (LAU/A28NER) Exhaust Muffler Replacement (LBS/A20DTH) Exhaust Muffler Replacement (Spare part) .

2. Remove the propeller shaft. Refer to Propeller Shaft Replacement .

3. Remove the bushing bolts and move aside the stabilizer shaft. Refer to Stabilizer Shaft Replacement (GNC) Stabilizer Shaft Replacement (GNE FWD) .


1

Protective Cover


Procedures

1. Unhook the protective cover from the hydraulic pump.

2. Undo the cable clips.

3. Remove the electrical connection.


2

Rear Axle Assembly Bolts (Qty: 4)

Warning

To prevent personal injury and/or component damage, support the differential case when removing the case from the axle housing. If the case is not supported, the differential case could fall and cause personal injury or damage to the differential case.


Refer to Fastener Caution .


Procedures

1. Support with a column jack.

2. Secure with cable ties.

3. Lower the differential clutch assembly just enough to reach the control module. Take care that the drive shaft universal joints are not damaged.

4. Use new bolts


Tighten

90 Nm (66 lb ft) + 90 degrees + 15 degrees

3

Control Module Bolts (Qty: 2)

Warning

The hydraulic pressure in the differential clutch is very high. To prevent personal injury, wait for at least 10 minutes before removing any parts from the differential clutch.


Tighten

6 Nm (53 lb in)

4

Sealing

5

Rear Differential Clutch Control Module

Procedures

Do not separate control module and valve.