SAAB WIS ONLINE

DTC C0569

DTC C0569

Diagnostic Instructions


• Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

• Review Strategy Based Diagnosis for an overview of the diagnostic approach.

• Diagnostic Procedure Instructions provides an overview of each diagnostic category.


DTC Descriptor

DTC C0569 00

System Configuration Malfunction

Circuit/System Description

The electronic brake control module (EBCM) receives controller area network (CAN) serial data messages from other modules. The EBCM must be configured with the vehicle identification number (VIN), CAN configuration data and vehicle options. If not properly configured after installation, the EBCM may set a DTC.

The internal fault detection is handle inside the control module. No external circuits are involved.

Conditions for Running the DTC

Ignition ON

Conditions for Setting the DTC

A mandatory control module is not programmed to the EBCM CAN configuration list.

Action Taken When the DTC Sets


• The EBCM disables the traction control, stability control and hill start assist for the duration of the ignition cycle.

• The traction control/stability control-active indicator turns ON.


Conditions for Clearing the DTC

A current DTC clears when the diagnostic runs and passes.

Diagnostic Aids

A newly replaced EBCM can set one or more DTC on its initial ignition ON cycle.

Reference Information

Schematic Reference

Antilock Brake System Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

ABS Description and Operation

Electrical Information Reference


• Circuit Testing

• Connector Repairs

• Testing for Intermittent Conditions and Poor Connections

• Wiring Repairs


Scan Tool Reference

Control Module References for scan tool information

Circuit/System Testing


1. Verify that DTC C0569 00 is not present.

2. If DTC C0569 00 is present, program the K17 Electronic Brake Control Module and verify the DTC does not reset.

3. If the DTC resets, replace the K17 Electronic Brake Control Module.


Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for EBCM replacement, setup and programming