Steering Linkage Outer Tie Rod Replacement

Callout

Component Name

Preliminary Procedure

Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .

Steering Linkage Outer Tie Rod Nut

Refer to Fastener Caution .

Install a new nut.

35 Nm (26 lb ft) + 40 degrees

Steering Linkage Inner Tie Rod Nut

60 Nm (44 lb ft)

Steering Linkage Outer Tie Rod

Use the CH-49455 Remover to separate the steering linkage outer tie rod from the steering knuckle.

Inspect the steering linkage inner tie rod for bent or damaged threads.

Clean the tapered surface of the steering knuckle.

Lubricate the steering linkage inner tie rod threads with chassis lubricant. Refer to Fluid and Lubricant Recommendations .

Adjust the front toe. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment .

Check Toe in. Adjust if neccessary. Refer to Wheel Alignment Specifications

Calibrate the Steering Angle Sensor. Refer to Steering Angle Sensor Centering

CH-49455 Ball Joint Remover

For equivalent regional tools, refer to Special Tools .