DTC C0569
DTC C0569 |
Diagnostic Instructions |
• |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
• |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
• |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
DTC Descriptor |
DTC C0569 00
System Configuration Malfunction
Circuit/System Description |
If the tire type and pressure selection information is not entered with the scan tool during the body control module (BCM) setup, the tire pressure monitor system indicator icon on the instrument cluster will flash for 1 min. and then remain illuminated after the ignition switch is cycled ON and the instrument cluster bulb check is complete. If equipped, the driver information center will also display a service tire monitor type message. Under these circumstances, DTC C0569 will be set and the tire type and pressure information will need to be entered for the system to function correctly.
Conditions for Running the DTC |
Ignition ON.
Conditions for Setting the DTC |
The BCM has not undergone the programming procedure.
Action Taken When the DTC Sets |
• |
The tire pressure monitor system indicator icon on the instrument cluster flashes for 1 min. and then remains illuminated after the ignition switch is cycled ON and the instrument cluster bulb check is complete.
|
• |
If equipped, the driver information center will also display a service tire monitor type message.
|
Conditions for Clearing the DTC |
A current DTC will clear when the BCM has undergone the tire type and pressure selection setup procedure and 1 ignition cycle has occurred.
Diagnostic Aids |
A newly replaced BCM will set DTC C0569 after programming on its initial ignition ON cycle if the module setup information has not been entered.
Reference Information |
Schematic Reference
Tire Pressure Monitoring System Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Tire Pressure Monitor Description and Operation
Electrical Information Reference
• |
Circuit Testing
|
• |
Connector Repairs
|
• |
Testing for Intermittent Conditions and Poor Connections
|
• |
Wiring Repairs
|
Scan Tool Reference
Control Module References
Circuit/System Verification |
Carry out body control module (BCM) programming and installation. Drive over 20 km/h (12 MPH) for 9 min.
Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References