DTC 41 or 42
DTC 41 or 42 |
Diagnostic Instructions |
• |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
• |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
• |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
DTC Descriptors |
DTC 41
Parking Heater Water Pump Circuit Open
DTC 42
Parking Heater Water Pump Circuit Low or Circuit High
Diagnostic Fault Information |
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
Parking Heater Water Pump Supply Voltage
|
42
|
41
|
42
|
-
|
Parking Heater Water Pump Ground
|
-
|
41
|
42
|
-
|
Circuit/System Description |
The parking heater uses the parking heater water pump motor to circulate coolant while the engine is not running.
Conditions for Running the DTC |
Ignition OFF. Battery voltage must be between 10-15 V.
Conditions for Setting the DTC |
parking heater has recognized out of range condition for more than 2.5 s.
Action Taken When the DTC Sets |
The parking heater will lock.
Conditions for Clearing the DTC |
DTC must be cleared with the remote control.
Reference Information |
Schematic Reference
HVAC Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Fuel Operated Heater Description and Operation
Electrical Information Reference
• |
Circuit Testing
|
• |
Connector Repairs
|
• |
Testing for Intermittent Conditions and Poor Connections
|
• |
Wiring Repairs
|
Circuit/System Verification |
Ignition OFF, command the parking heater ON and OFF with the remote control. Verify the coolant pump turns ON and OFF with the heater.
Circuit/System Testing |
1. |
Ignition OFF, parking heater OFF, disconnect the G17 Heater Coolant Pump.
|
2. |
Ignition OFF, test for less than 5 Ω between the low reference circuit terminal B and ground.
|
3. |
If greater than the specified range, replace the K87 Parking Heater Control Module.
|
4. |
Install a test lamp between the control circuit terminal A and low reference circuit terminal B.
|
5. |
Command the parking heater ON and OFF using the remote control. Verify the test lamp turns ON and OFF with each command.
|
6. |
If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the K87 Parking Heater Control Module.
|
7. |
If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K87 Parking Heater Control Module.
|
8. |
If all circuits test normal, test or replace the G17 Heater Coolant Pump.
|
Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.