DTC B3265
DTC B3265 |
Diagnostic Instructions |
• |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
• |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
• |
Diagnostic Procedure Instructions
has overviews of all diagnostic categories.
|
DTC Descriptor |
DTC B3265 02
Trunk Lid Unlatch Output Circuit Short to Ground
Diagnostic Fault Information |
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
Trunk Relay B+
|
1
|
1
|
-
|
-
|
Rear Compartment Lid Unlatch Actuator Control
|
1
|
1
|
1
|
-
|
Trunk Release Relay Control
|
B3265 02
|
1
|
1
|
-
|
Rear Compartment Lid Unlatch Actuator Ground
|
-
|
1
|
1
|
-
|
Trunk Relay Ground
|
-
|
1
|
1
|
-
|
1. Rear Compartment Lid Unlatch Malfunction
|
Circuit/System Description |
The body control module (BCM) applies battery positive voltage to the trunk release relay control circuit, which energizes the coil side of the rear compartment lid release relay. The switch side of the rear compartment lid release relay then closes, supplying battery positive voltage through the relay and the latch motor voltage control circuit to the rear compartment lid latch. The rear compartment lid latch then releases the rear compartment lid so that it may be manually raised to an open position.
Conditions for Running the DTC |
Battery voltage must be between 9-16 V.
Conditions for Setting the DTC |
The BCM detects a short to ground on the trunk release relay control circuit.
Action Taken When the DTC Sets |
The rear compartment latch will not operate.
Conditions for Clearing the DTC |
• |
This DTC will be current for as long as the fault is present.
|
• |
When the fault is no longer present, the DTC will be a history DTC.
|
• |
A history DTC will clear after 50 ignition cycles.
|
Reference Information |
Schematic Reference
Release Systems Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Luggage Compartment Description and Operation
Electrical Information Reference
• |
Circuit Testing
|
• |
Connector Repairs
|
• |
Testing for Intermittent Conditions and Poor Connections
|
• |
Wiring Repairs
|
Scan Tool Reference
Control Module References for information on diagnostic tools
Circuit/System Verification |
Ignition ON, command the Trunk Lid Unlatch with a scan tool. The rear compartment lid actuator should unlatch the trunk lid.
Circuit/System Testing |
1. |
Ignition OFF, disconnect the X5 harness connector at the K9 Body Control Module.
|
2. |
Test for greater than 50 Ω between the control circuit terminal 11 X5 and ground.
|
3. |
If less than the specified range, test the control circuit for a short to ground. If the circuit tests normal, replace the X50A Fuse Block - Underhood.
|
4. |
If all circuits test normal, replace the K9 Body Control Module.
|
Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
• |
Control Module References
for information on BCM replacement, setup, and programming
|
• |
Underhood Electrical Center or Junction Block Replacement
|