Power Mirror Folding Malfunction (without A45)
|
Power Mirror Folding Malfunction (without A45)
|
Diagnostic Fault Information
|
Circuit
|
Short to Ground
|
Open/High Resistance
|
Short to Voltage
|
Signal Performance
|
Folding Mirror Motor Fold Control
|
1
|
1
|
-
|
-
|
Folding Mirror Motor Unfold Control
|
1
|
1
|
-
|
-
|
1. Folding electric rear-view mirror inoperative/malfunctioning
|
Circuit/System Description
|
The outside mirror switch controls the power fold/unfold functions of the outside rearview mirrors. The folding mirror motors are controlled by using bi-directional motor controls through the folding mirror motor fold control circuit and the folding mirror motor unfold control circuit.
Schematic Reference
Outside Rearview Mirror Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Outside Mirror Description and Operation (w/o A45)
Outside Mirror Description and Operation (with A45)
Electrical Information Reference
Scan Tool Reference
Control Module References
for information on diagnostic tools
Circuit/System Verification
|
Ignition ON, operate the mirror switch fold/unfold functions. The outside mirrors should fold and unfold.
Note
|
Circuit/system verification must be carried out before circuit/system testing.
|
1.
|
Ignition OFF, disconnect the harness connector at the appropriate A9 outside rearview mirror.
|
2.
|
Connect a test lamp between the control circuit terminal 9 and the control circuit terminal 10.
|
3.
|
Operate the outside mirror switch fold/unfold functions. The test lamp should turn ON when commanding the fold and unfold states.
|
4.
|
If the test lamp remains OFF during either of the commands, test for a short to voltage, short to ground, or an open/high resistance on either control circuit. If the circuits test normal, replace the S52 outside mirror switch.
|
5.
|
If all circuits test normal, test or replace the A9 outside rearview mirror.
|
Perform the
Diagnostic Repair Verification
after completing the diagnostic procedure.