SAAB WIS ONLINE

Four Wheel Drive Rear Axle Switch Wiring Harness Replacement

Four Wheel Drive Rear Axle Switch Wiring Harness Replacement



Callout Component Name

Preliminary Procedure

1. Disconnect the battery negative cable. Refer to Battery Negative Cable Replacement (Gasoline) .

2. Remove the rear wheel left side. Refer to Tire and Wheel Removal and Installation .

3. Remove the muffler. Refer to Exhaust Muffler Replacement (LAU/A28NER) Exhaust Muffler Replacement (Spare part) Exhaust Muffler Replacement (LBY/A20DTR) Exhaust Muffler Replacement (LBS/A20DTH) Exhaust Muffler Replacement (LHU/A20NFT, LLU/A16LET) .

4. Remove the propeller shaft. Refer to Propeller Shaft Replacement .

5. Remove the tank. Refer to Fuel Tank Replacement .

6. Lower the transfer case approximately 20 mm (0.8 in). Refer to Rear Axle Replacement (G96) Rear Axle Replacement (Without G96) .


1

Four Wheel Drive Rear Axle Switch Wiring Harness


Procedure

1. Release the base retainer from the inner wheelhouse.

2. Remove the protective cover from the rear drive control module.

3. Disconnect the electrical connector at the rear drive control module and in the inner wheelhouse.

4. Release the 8 retainers.

5. Remove the old wiring harness.