SAAB WIS ONLINE

Selector lever

Selector lever

Removal



1. Remove the selector lever housing, see .

2. Release the wiring by cutting the cable tie.

3. Remove the electro-magnet. (Only in cars with shift-lock function.)

4. Remove the lever by removing the nut and pulling out the ball socket.


Note

There is a washer between the lever and the metal housing.


5. Release the plastic housing which is secured with snap-on hinges in the metal housing.

6. Pull out the selector lever's shaft from its securing point.


Fitting



1. Move the bulbs and the WINTER switch to the new selector lever.

2. Grease the selector lever's shaft, the bushings in the securing point and the linkage with Berusil FO22F, part no 42 38 671 or similar.

3. Press the selector lever's shaft into the securing point.

4. Refit the lever. Do not forget the washer!

Tightening torque: 30 Nm (22 lbf ft)

5. Refit the plastic housing, make sure that it snaps on properly.

6. Refit the electro-magnet and adjust the shift-lock function, see .


7. Secure the wiring to the housing with cable ties.

8. Adjust the play in the parking-lock, see .

9. Refit the selector lever housing to the car body, see .