INSTALLATION

INSTALLATION

Install the water pump onto cylinder block (LH).

Note
•	Replace the gasket with a new one.
•	When installing the water pump, tighten bolts in two stages in alphabetical sequence as shown in the figure.

Tightening torque:

First:

12 Nm (1.2 kgf-m, 8.7 ft-lb)

14 Nm (1.4 kgf-m, 10.2 ft-lb)

Connect the hose to water pump.

Install the tensioner bracket.

Tightening torque:

25 Nm (2.5 kgf-m, 18.1 ft-lb)

Install the belt cover No. 2 (LH).

Tightening torque:

5 Nm (0.5 kgf-m, 3.6 ft-lb)

Install the camshaft sprockets (LH) by using ST.

Install the camshaft position sensor.

Install the belt idler No. 2 (C).

Install the belt idler (B).

Install the automatic belt tension adjuster (A) which has tension rod held by pin.

Tightening torque:

39 Nm (4.0 kgf-m, 28.9 ft-lb)

Install the timing belt.

Install the V-belts.

Install the radiator.