SAAB WIS ONLINE

CHECK POWER SUPPLY AND GROUND LINE OF ENGINE CONTROL MODULE (ECM)

CHECK POWER SUPPLY AND GROUND LINE OF ENGINE CONTROL MODULE (ECM)

Important

After repair or replacement of faulty parts, conduct Clear Memory Mode and Inspection Mode .


WIRING DIAGRAM:


CHECK MAIN RELAY.

Turn the ignition switch to OFF.

Remove the main relay.

Connect the battery to main relay terminals No. 1 and No. 2.

Measure the resistance between main relay terminals.

Terminals

No. 3 — No. 5:

No. 4 — No. 6:

Is the measured value less than 10 Ω?

Yes


No

Replace the main relay.


CHECK GROUND CIRCUIT OF ECM.

Disconnect the connector from ECM.

Measure the resistance of harness between ECM and chassis ground.

Connector & terminal

(B134) No. 6 — Chassis ground:

(B134) No. 7 — Chassis ground:

(B135) No. 12 — Chassis ground:

(B137) No. 1 — Chassis ground:

(B137) No. 2 — Chassis ground:

(B135) No. 1 — Chassis ground:

(B135) No. 4 — Chassis ground:

(B137) No. 7 — Chassis ground:

Is the measured value less than 5 Ω?

Yes


No

Repair the open circuit in harness between ECM connector and engine grounding terminal.


CHECK INPUT VOLTAGE OF ECM.

Measure the voltage between ECM connector and chassis ground.

Connector & terminal

(B135) No. 19 (+) — Chassis ground (−): (B137) No. 15 (+) — Chassis ground (−):

Is the measured value more than 10 V?

Yes


No

Repair the open or ground short circuit of power supply circuit.


CHECK INPUT VOLTAGE OF MAIN RELAY.

Measure the voltage between main relay connector and chassis ground.

Connector & terminal

(B47) No. 1 (+) — Chassis ground (−):

(B47) No. 5 (+) — Chassis ground (−):

(B47) No. 6 (+) — Chassis ground (−):

Is the measured value more than 10 V?

Yes


No

Repair the open or ground short circuit in harness of power supply circuit.


CHECK INPUT VOLTAGE OF ECM.

Connect the main relay connector.

Turn the ignition switch to ON.

Measure the voltage between ECM connector and chassis ground.

Connector & terminal

(B135) No. 5 (+) — Chassis ground (−):

(B135) No. 6 (+) — Chassis ground (−):

(B137) No. 17 (+) — Chassis ground (−):

Is the measured value more than 10 V?

Yes

Check the ignition control system.


No

Repair the open or ground short circuit in harness between ECM connector and main relay connector.