SAAB WIS ONLINE

INSTALLATION

INSTALLATION

Check the appearance of each component and clean.

Force-fit the oil seal to the converter case with ST.

ST 32005058 DRIFT


Install the differential assembly to the case.

Install the left and right side retainers.

Install the new seal pipe to the converter case.


(A)

Seal pipe



Install the rubber seal to the converter case.


(A)

Rubber seal



Apply proper amount of liquid gasket to the entire converter case mating surface.

Liquid gasket:

THREE BOND 1215 (Part No. 32005013)


(A)

THREE BOND 1215

(B)

Rubber seal



Install the converter case assembly without damaging bush and oil seal and secure with six bolts and four nuts.

Tightening torque:

41 Nm (4.2 kgf-m, 30.4 ft-lb)


Insert inhibitor switch and transmission connector into stay.

Install air breather hose.

Install the oil cooler pipes.

Install the oil charge pipe with O-ring.

Insert the input shaft while turning lightly by hand and verify the protrusion amount.

Normal protrusion A:

50 — 55 mm (1.97 — 2.17 in)


Install the torque converter clutch assembly.

Install the transmission assembly to the vehicle.