INSTALLATION
INSTALLATION |
Install the differential assembly to the case, paying special attention not to damage the inside of the case (particularly, the differential side retainer contact surface).

(A)
|
Differential
assembly
|
Install the O-rings from left and right side retainer.
Using ST, install the side retainers.

ST 32005023 WRENCH ASSY
Adjust the front differential backlash.
Install the lock plate.
Tightening torque:
25 Nm (2.5 kgf-m, 18.1 ft-lb)

(A)
|
Lock plate
|
Install the new seal pipe to the converter case.

(A)
|
Seal pipe
|
Install the converter case to transmission case.

Insert inhibitor switch and transmission connector into stay.

(A)
|
Transmission
harness
|
(B)
|
Inhibitor
switch harness
|
Install oil cooler pipes.

Install the oil charge pipe with O-ring

Insert the input shaft while turning lightly by hand and verify the protrusion amount.
Normal protrusion A:
50 — 55 mm (1.97 — 2.17 in)

Install the torque converter clutch assembly.

Install the transmission assembly to the vehicle.
