SAAB WIS ONLINE

DTC B3873

DTC B3873

Diagnostic Instructions


• Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

• Review Strategy Based Diagnosis for an overview of the diagnostic approach.

• Diagnostic Procedure Instructions has overviews of all diagnostic categories.


DTC Descriptor

DTC B3873 02

Front Washer Relay Circuit Short to Ground

Diagnostic Fault Information

Circuit Short to Ground Open/High Resistance Short to Voltage Signal Performance
Windshield Washer Switch Signal

2

1

1

-

Windshield Washer Fluid Pump Control

1

1

2

-

Windshield Washer Relay Control

B3873 02

1

2

-

Windshield Washer Fluid Pump Ground

-

1

1

-

1. Front Washer Inoperative

2. Front Washer Always ON



Circuit/System Description

The body control module (BCM) controls the windshield washer fluid pump based on an input from the window wiper/washer switch. The BCM monitors the washer switch through the windshield washer switch signal circuit. When the WASH switch is closed, ground is supplied to the front washer switch signal circuit. If this is the case, the BCM will activate the windshield washer's fluid pump and the low speed wipers on.

Conditions for Running the DTC


• Ignition ON.

• The system voltage is between 9-16 V.


Conditions for Setting the DTC

A short to ground is detected in the windshield washer relay control circuit.

Action Taken When the DTC Sets

Washer operation is suspended.

Conditions for Clearing the DTC

A current DTC clears when the diagnostic runs and passes.

Reference Information

Schematic Reference

Wiper/Washer Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Wiper/Washer System Description and Operation

Electrical Information Reference


• Circuit Testing

• Connector Repairs

• Testing for Intermittent Conditions and Poor Connections

• Wiring Repairs


Scan Tool Reference

Control Module References for information on diagnostic tools

Circuit/System Verification

Operate the front washer by using the S80 Window Wiper/Washer Switch. Verify the G24 Windshield Washer Pump activates.

Circuit/System Testing


1. Ignition OFF, disconnect the harness connector X2 at the X50A Fuse Block - Underhood.

2. Disconnect the harness connector X4 at the K9 Body Control Module.

3. Ignition OFF, test for less than 5 Ω between the signal circuit terminal 60 X2 at the X50A Fuse Block - Underhood and the signal circuit terminal 14 X4 at the K9 Body Control Module.

4. If the value is greater than the specified range, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, test or replace the K9 Body Control Module.

5. If all circuits test normal, test or replace the X50A Fuse Block - Underhood.


Component Testing

Output Control Tests

Ignition ON, command the Windshield Washer Relay Command ON and OFF with a scan tool. Observe that the KR11 Windshield Washer Pump Relay clicks and the G24 Windshield Washer Pump runs.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.


• Control Module References for information on BCM replacement, setup, and programming

• Windshield Washer Pump Replacement (Sedan)