DTC B369D
DTC B369D |
Diagnostic Instructions |
• |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
• |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
• |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
DTC Descriptors |
DTC B369D 00
Sunroof Sunshade Actuator Malfunction
DTC B369D 39
Sunroof Sunshade Actuator Internal Malfunction
DTC B369D 42
Sunroof Sunshade Actuator Calibration Not Programmed
DTC B369D 4B
Sunroof Sunshade Actuator Calibration Not Programmed
Circuit/System Description |
The sunshade is controlled by its own integrated motor/controller containing the necessary electronics, motor, hall effect position sensors, as well as the interface to the driver control switches. The motor/controller is capable of controlling motion based on control switch activation and LIN-Bus message commands from the body control module (BCM).
Conditions for Running the DTC |
The ignition is ON.
Conditions for Setting the DTC |
B369D 00
The sunshade module has detected and reported via the LIN-Bus that the sunshade actuator has an malfunction.B369D 39
The sunshade module has detected and reported via the LIN-Bus that the sunshade actuator has an malfunction.B369D 42
The sunshade module has detected and reported via the LIN-Bus that the sunshade actuator calibration is not programmed.B369D 4B
The sunshade module has detected and reported via the LIN-Bus that the sunshade actuator calibration is not programmed.Action Taken When the DTC Sets |
DTC B369D is stored in the BCM memory.
Conditions for Clearing the DTC |
The BCM no longer detects a malfunction in the sunshade actuator circuit.
Reference Information |
Schematic Reference
Sunroof Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Sunroof Description and Operation (Spoiler System) Sunroof Description and Operation (Tilt and Slide System)
Electrical Information Reference
• |
Circuit Testing
|
• |
Connector Repairs
|
• |
Testing for Intermittent Conditions and Poor Connections
|
• |
Wiring Repairs
|
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification |
1. |
Verify that DTC B369D 42 or DTC B369D 4B is not set.
|
2. |
If the DTC is set, program or calibrate the K62 Sunroof Sunshade Motor Module. If the DTC resets, replace the K62 Sunroof Sunshade Motor Module.
|
3. |
Replace the K62 Sunroof Sunshade Motor Module.
|
Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
• |
Sunroof Sunshade Motor Replacement
|
• |
Control Module References
for sunshade motor/actuator replacement, setup and programming
|