Fuel Tank Replacement
Fuel Tank Replacement |
Removal Procedure |
Refer to Gasoline/Gasoline Vapors Warning .
1. |
Relieve the fuel system pressure. Refer to
Fuel Pressure Relief
.
|
2. |
Drain the fuel tank. Refer to
Fuel Tank Draining
.
|
3. |
Remove the exhaust system. Refer to
Exhaust Muffler Replacement (LAU)
Exhaust Muffler Replacement (LF1)
.
|
4. |
If required, remove the propeller shaft. Refer to
Propeller Shaft Replacement
.
|
5. |
Disconnect the evaporative emission line (1). Refer to
Plastic Collar Quick Connect Fitting Service
.
|
6. |
Loosen the upper fill pipe clamp and hose clamp (2) and slide the hose up the filler pipe.
|
7. |
Disconnect the fuel tank electrical connector (1).
|
8. |
Disconnect the fuel line and evaporative emission line connectors (2). Refer to
Plastic Collar Quick Connect Fitting Service
.
|
9. |
Disconnect the evaporative emission line (1) from the canister.
|
10. |
Support the fuel tank with a suitable jack.
|
11. |
Remove the fuel tank strap bolts (1) and reposition the straps (2) downward toward the front of the vehicle.
|
12. |
Using a suitable jack, lower the fuel tank (3).
|
13. |
Remove the following components if replacing just the fuel tank:
|
• |
The primary fuel tank module-Refer to
Primary Fuel Tank Module Replacement (NA3, NE9, NF9)
Primary Fuel Tank Module Replacement (NT7, NU5)
.
|
• |
The secondary fuel tank module-Refer to
Secondary Fuel Tank Module Replacement
.
|
Installation Procedure |
1. |
Install the following components if fuel tank replacement was necessary:
|
• |
The primary fuel tank module-Refer to
Primary Fuel Tank Module Replacement (NA3, NE9, NF9)
Primary Fuel Tank Module Replacement (NT7, NU5)
.
|
• |
The secondary fuel tank module-Refer to
Secondary Fuel Tank Module Replacement
.
|
2. |
Raise the fuel tank (3) to the vehicle.
|
3. |
Refer to
Fastener Caution
.
Ensure the fuel tank straps are seated properly. Install the fuel tank straps (2) and bolts (1) then tighten to 45 Nm (33 lb ft). |
4. |
Connect the evaporative emission line (1) to the canister.
|
5. |
Connect the fuel tank electrical connector (1).
|
6. |
Connect the fuel line and evaporative emission line connectors (2). Refer to
Plastic Collar Quick Connect Fitting Service
.
|
7. |
Connect the evaporative emission line (1). Refer to
Plastic Collar Quick Connect Fitting Service
.
|
8. |
Install the filler pipe and tighten both hose clamps (2) to
5 Nm (44 lb in)
.
|
9. |
Perform a leak down test. Refer to
Evaporative Emission System Diagnosis
.
|
10. |
If required, install the propeller shaft. Refer to
Propeller Shaft Replacement
.
|
11. |
Install the exhaust system. Refer to
Exhaust Muffler Replacement (LAU)
Exhaust Muffler Replacement (LF1)
.
|
12. |
Refill the fuel tank.
|
13. |
Inspect for fuel leaks.
|