SAAB WIS ONLINE

Measured values, control module connections

Measured values, control module connections




Scope

Nominal values and instructions for measuring voltages on the control module can be found under the respective headings below.

Remember


Note the measuring conditions and use common sense when assessing the results.

The nominal values shown apply with the ignition switched ON unless otherwise stated.

First, check that the power supplies to the module are correct and that it is grounded properly.

Then check all the sensor inputs and signals from other systems.

Finally, check the outputs. Remember that the measured values do not tell us whether or not the module is functioning properly.

If any reading is not OK, consult the wiring diagram to trace the leads, connectors or components which should be checked more thoroughly.

The nominal values shown below apply when using a calibrated Fluke 88/97.

The values % (+) and ms (+) show the pulse ratio and pulse duration of the signal. The test instrument used must be able to measure pulse ratio and pulse width. The (+) sign denotes a positive trigger pulse, TRIG+.





> = greater than; < = less than; » = approx. equal to; ~ = AC voltage (LP: LOGIC PROBE P = select pulse; p = visible pulses); LH = left-hand; RH = right-hand

Pin no.

Lead colour

Component/

Function

In/output

Measuring conditions

Measure across

Nominal value

See

1

YE/RD

Brake light right-hand, voltage measurement from TWICE to lamp bulb.

Out

Brake pedal depressed.

1-B-

B+

Lighting and signalling system



2

No connection.









3

GN/WH

Electric powered passenger seat, relay ground.

Out

Ignition ON

3-B-

approx. 1 V

Seats











Ignition OFF. Front doors closed.

Not affected.

3-B-

B+



4

BU/WH

Starter relay, ground

Out

Ignition switch in ST position.

Transponder not OK.

4-B-

B+

Theft protection











Ignition switch in ST position.

Transponder OK.

4-B-

<0.5V



5

LHD: GN/WH

RHD: GN/WH

Seat sensor, passenger seat.

In

Passenger seat occupied.

5-21

<4.2V

Seat belt system









Passenger seat not occupied.

5-21

5V



6

BU/RD

Switch, locking central locking, centre console.

In

Ignition ON.

6-B-

B+ for approx. 0.5 sec.

Doors and locks



7

BN/RD

Switch, unlocking central locking, centre console.

In

Ignition ON.

7-B-

B+ for approx. 0.5 sec.

Doors and locks



8



No connection.











9

GN/BK

Heater pad rear seat, request.

In

Ignition ON:

Pushbutton rear seat heater pad kept depressed.

9-B-

B+

Seats



10

RD/WH

Glass breakage sensor and tilt sensor, power supply.

Out

Sensor not disconnected.

Anti-theft alarm armed.

10-B-

B+

Theft protection





11

YE

Switch unlocking of boot lid.

In

Ignition ON.

11-B-

B+ for approx. 0.5 sec.

Doors and locks



12

YE/WH

Door switch, left-hand rear door.

In

Ignition ON:

Door closed

12-B-

B+ for approx. 0.5 sec.



Theft protection



13

VT/WH

Remote control receiver, ground.

In

Always

B+ -13

13-B-

B+

<0.5V



Theft protection



14

YE/BN

Remote control receiver, anti-theft alarm, signal.

In

Remote control not affected.

14-B-

B+

Theft protection









Press in locking button.

14-B-

approx. 6V for approx. 0.2 sec.



15

WH

I-bus (-)



In/Out

Ignition ON:

Bus active

15-B-

2-3V



16

BU/RD

Ignition +15, logic.



In

Ignition ON.

16-B-

B+



17

OG

Ignition +B, logic.

In

Ignition ON:

Key in ignition switch

17-B-

B+



18

LHD: BU/RD

RHD: BN/WH

Seat belt switch, driver's side.

In

Ignition ON:

Seat belt on driver's side not connected in buckle

18-B-

<0.5V

Seat belt system



Belt connected



18-B-

B+





19

GN

Tilt sensor signal.

In

Ignition ON

19-B-

1.0V

Theft protection



20

RD/WH

Central locking motors rear doors, control voltage anti-theft protection locking

Out

Not affected

B+ -20

B+

Doors and locks



Lock the car.

Then activate the function with the diagnostics tool.

20-B-

B+ -20

B+

<1V



21

GN/WH

Seat sensor passenger seat, ground.



Out

Ignition ON.

B+ -21

B+

Seat belt system



22

BU/GN

Central locking motors doors, control voltage locking

Out

Not affected

B+ -22

B+

Doors and locks



The car must not be locked.

Then activate the function with the diagnostics tool.

22-B-



B+ -22

B+



<1V



23

GN

Parking light left-hand rear, power supply from switch.

In

Light switch in parking light position (pos 1)

23-B-

B+

Lighting and signalling system



24

RD/BK

High-level brake light, power supply from TWICE to lamp bulb.

Out

Brake pedal depressed.

24-B-

B+

Lighting and signalling system



25

GY/RD

Brake light left-hand, power supply from TWICE to lamp bulb.

Out

Brake pedal depressed.

25-B-

B+

Lighting and signalling system



26

BK/GN

Central locking motor driver's door, control voltage unlocking

Out

Not affected

B+ -26

B+

Doors and locks





The car must not be locked.

Then activate the function with the diagnostics tool.

26-B-



B+ -26

B+



<1V



27

GN/YE

LED, anti-theft protection

Out

Activate function with diagnostics tool.

B+ -27

approx. 1.95 V

Theft protection



28

BK/VT

Seat belt warning lamp, ground.

Out

Ignition ON

28-B-

<1V for 6 secs.

Seat belt system







Seat belt buckled, more than 6 secs. since ignition was switched ON.

28-B-

B+



29

GN/YE

Siren, communication



Out

Ignition ON.

29-B-

B+

Theft protection



30



No connection.











31



No connection.











32



No connection.













33

BU/YE

Unlocking with key in driver's door.



In

Ignition ON.

B+ -33

approx. 8V for 0.5 sec

Doors and locks



34

BN/WH

Tilt sensor, ground.

In

Always

B+ -34

34-B-

B+

<0.5V



Theft protection



35

GN/GY

Luggage compartment switch.

In

Ignition ON:

Tailgate closed.

35-B-

B+ for approx. 0.5 sec.



Theft protection









Tailgate open.

35-B-

<0.1V





36

GN

Door switch; right-hand rear door.

In

Ignition ON:



Door closed.

36-B-

B+ for approx. 0.5 sec.



Theft protection











Door open.

36-B-

<0.1V





37

BK

Signal ground.



In

Always.

B+ -37

37-B-

B+

<0.5V





38

GN

I-bus (+)



In/Out

Ignition ON:

Bus active.

38-B-

2-3V



39

YE/BN

Immobilization; code from antenna unit near ignition switch.

In

Ignition ON.

39-B-

B+



Theft protection









Ignition OFF.

B+ -39

<0.1V





40



No connection.











41

BU

Bonnet switch.

In

Ignition ON:

Bonnet closed.

41-B-

B+ for approx. 0.5 sec.

Theft protection









Bonnet open.

41-B-

<0.1V







42

BN/GN

Central locking motor driver's door, control voltage, anti-theft locking.

The car must be locked.

Out

Not affected

B+ -42

B+

Doors and locks





Activate function with diagnostics tool.

42-B-



B+ -42

B+



<1V





43

RD

TWICE, power supply +30.

In

Always +30

43-B-

B+ -43

B+

<0.5V





44



No connection.











45

GN

Parking light left-hand rear, power supply from TWICE to lamp bulb.

Out

Light switch in parking light position (pos 1)

45-B-

B+

Lighting and signalling system



46

BU

Parking light right-hand rear, power supply from switch.

In

Light switch in parking light position (pos 1)

46-B-

B+

Lighting and signalling system



47

RD

Central locking, power supply from fuse.

In

Always +30.

Activate any central locking function.

47-B-

B+ -47

B+

<1V



Doors and locks



48

GN/GY

Brake light, power supply from brake light switch.

In

Brake pedal depressed.

48-B-

B+

Lighting and signalling system



49

GN/YE

Central locking motors rear doors, control voltage unlocking.

Out

Not affected

B+ -49

B+

Doors and locks









Activate function with diagnostics tool.

49-ground

B+ -49

B+

<1V





50

GN

Antenna unit immobilization; power supply.

Out

Ignition ON:

Without transponder

50-B-

B+ for approx. 10 secs.



Theft protection











Ignition ON:

With transponder

50-B-

B+ for approx. 0.1 secs.





51



No connection.













52

GN

Electric heater rear seat, relay.

Out

Activate with diagnostics tool.

52-B-

approx. 1 V



Seats









Not affected

52-B-

B+





53



No connection.











54



No connection.











55

BU/RD

Lock button, driver's door.



In

Ignition ON:

Lock button up.



55-B-



0V



Doors and locks











Lock button down.

55-B-

B+ for approx. 0.5 sec.



56

BK/WH

Locking with key in driver's door.

In

Ignition ON.



56-B-

8V for approx. 0.5 secs.

Doors and locks













Key in door lock in locked position.

56-B-

0V





57

BU/RD

Glass breakage sensor, ground.

In

Always

B+ -57

57-B-

B+

<0.5V



Theft protection



58

BU/YE

Glass breakage sensor, signal.

In

Ignition ON.

58-B-

B+ for approx. 0.5 sec.

Theft protection



59

BU

Tailgate switch for disarming anti-theft alarm.

In

Ignition ON:

Not affected

59-B-

B+ for approx. 0.5 sec.

Theft protection









Turn key to unlocked position.

59-B-

<0.1V



60

GN/BU



Door switch passenger door, front

In

Ignition ON:

Door closed.



60-B-

B+ for approx. 0.5 sec.

Theft protection









Door open.



60-B-

<0.1V



61

BU/RD



Door switch, driver's door

In

Ignition ON:

Door closed.



61-B-

B+ for approx. 0.5 sec.

Theft protection









Door open.



61-B-

<0.1V



62















63



No connection.











64



No connection.















65

LHD: BN/RD

RHD: BU/WH

Seat belt switch, passenger side

In

Ignition ON:

Seat belt on passenger side not connected in buckle



65-B-

<0.5V

Seat belt system







Seat belt buckled



65-B-

B+



66

GN/BK

Central locking motor passenger door front, control voltage, anti-theft locking.

Out

Not affected

B+ -66

B+

Doors and locks









Lock the car

Activate function with diagnostics tool.

66-B-

B+ -66

B+

<1V



67

GN/WH

Central locking motor tailgate, control voltage.

Out

Not affected

B+ -67

B+

Doors and locks









Activate function with diagnostics tool.

67-B-

B+ -67

B+

<1V



68

BU

Parking light right-hand rear, power supply from TWICE to lamp bulb.

Out

Light switch in parking light position (pos 1)

68-B-

B+

Lighting and signalling system



69

VT/WH

Central locking motor passenger door front, control voltage unlocking.

Out

Not affected

B+ -69

B+

Doors and locks









Activate function with diagnostics tool.

69-B-

B+ -69

B+

<1V



70

BK

Power ground TWICE



In

Always.

Operate central locking function.

B+ -70

70-B-

B+

<0.3V